FL Sanctuary Bibs and an original LW Assault stand, both should arrive Monday. I'm hoping to put both to use wrapping up this year.
Got some lacrosse aerohead 7mm boots a few weeks ago, got some realtree Walmart liner socks and a few pairs of heat holder socks on black Fri.
Sitka Fanatic jacket and bibs.... and the tool bucket. Now I just need it to get cold enough here to wear.
There coming next...one of them is going to be my open county rig. I bought a 60 pound Elite Spirit to replace my e32 for my primary whitetail set up.
Nice. What's your draw length? I assume the cam is more efficient in the upper end of the draw length range like the Hoyt cams. And will you go 31 or 34 for your open country bow? Sent from my iPhone using Tapatalk
I am 28.5, the cam maxes at at 28. but i can get a little more length off it if I try and adjust with the D loop as well. figure it will max at 61-62. I am hoping i get the numbers out of it that i think i will. I tuned one with a 26" draw for a friend it it was sweet...it had me thinking that I should play with one for myself. I am not sure if I want the I31 or the I34, i need to mull it over a bit. If the mass weight was a little less then i would take the I34 for sure...but its kind of heavy. I am holding off till after the ATA because I want to see that New Breed is doing, they are the only other company right now that may put out a Binary cam bow that could interest me.
Yeah that sounds like a great idea. Yeah for an open country bow, putting on a lot of miles the I34 might be a little heavy Sent from my iPhone using Tapatalk
Yea, I really want a bare bow weight right at 4 pounds or even a little under as starting point but it isnt a deal breaker.
You're only a 28.5" draw Trials????? That's my draw length and I'm quite sure that I am a lot smaller than you are!
I havent even shot one yet!! dont tell me that you will cost me money I been hearing there is little bit of a hump an dump? what do you think? hows the draw cycle?
Very typical elite smooth draw. Little hump but not really too bad. Sent from my iPhone using Tapatalk
that is what I needed to hear. I am sure I can adjust the stops a bit and smooth it out after I advance the cams. At 28.5 i should be in sweet spot as far a smoothness...the only issues I have seen were with longer draw lengths. I am going to start looking for one with 65# limbs. i already built a a special moose arrow!! now i need the bow..