So i was looking at the timing of the draw stops on my Z5 cams # 2 set at 27 in draw and the top draw stop hits like 1/4" before the bottom. Is that good? I havnt set it up and tunned or shot it yet was just checking the stops. The top stop is built in the draw mod so cant move that but the bottom i can move. Any advice? thanks
generally no. That is too far advanced. You need to set your timing. I will usually have the top cams set just slightly ahead....no where near 1/4....
1/4" is definitely a bit much but it should tune well there. You should be able to put 1/2 to one twist in the control cable to fix it. 1/8" advance is about perfect.
