I picked up this trail cam new at a severely discounted price this past fall. I didn't get a chance to really use it until recently and am having a slight problem programming it. If any of you have this camera & can get me on track to program it as noter below, I'd appreciate your help. This is what I would like to do. There is a bear frequenting a neighbors back yard & I'd like to get some picture of it. I'd like to be able to take these pictures every day from 10 PM to 6 AM. This is how I've programmed it so far: In Setup Mode I advance to the "TIME-Lapse Start screen. I set the time to 20:00 hours (military time) to start taking pictures at 10 PM. While still in the Setup Mode, I then advance to the "TIME-LAPSE FREQUENCY" screen. Using the Up/Down arrow I select a Frequency of 8 hours as the interval period. This is to allow pictures to be taken until 6 AM (8 hours from the 10 PM start time). Back at the top menu I advance to the "TIME-LAPSE MODE" 7 leave the camera on in this mode. After leaving the camera operating for a week I checked the results. What I found was a bit different than what was expected. The camera took pictures at 10 PM, at 6 AM, and at 2 PM (notice the 8 hr intervals). This is not what I was looking for. I was hoping to have pictures taken for only one 8 hr. period from 10 PM to 6 AM. How do I change the programming to do this? Do I enter info at the "TIME-LAPSE MODE" to program a "delay" of 16 hrs (from 6 AM to 10 PM) until the next time the camera is to take pictures, which would be at 10 PM? What am I missing here? Thanks for your help. PS I have called Moultrie Feeders several times & the CS rep is not up to speed on programming trail cams & whenever she tries to transfer me to a tech rep I get disconnected.
