I just bought a new bear bow and the guy at the shop had to move the peep sight and when I tried to sight it in its bottomed out and it's still 2in high any suggestions would be appreciated
Agreed. Check out the setup first. Arrow should sit level and be centered to the berger holes. What is the peep sight distance from the nock point?
I went and got it paper tuned and lowered the nock and rest to the center of the Berger hole but it's still very close to being bottomed out. Its 6 3/4 from center of peep to center of nock
I'm a lil irrated at that shop I was telling him that it came with two grips for this bow and there the rubber ones he gave me a plastic one that dont fit the bow
That's not a crazy distance but I would draw the bow with your eyes closed and anchor it and then open and see if the peep is below or above your sight line.
No, you don’t move the nocking point for sighting in. Moving the nocking point is for tuning. Sent from my iPad using Tapatalk
You say you are “bottomed” out, but shooting high. You should be moving pin up if shooting high. If you can’t move pin up any further, then peep needs to go up. Either way, peep needs to move if maxed out on sight.