Looks good! My son and I built something similar out of pvc years ago. Sent from my SM-S727VL using Tapatalk
Damn, that is a lot of bone!
I am fighting a bit of anxiety when the shot comes. Been thinking of making the switch from a wrist release to a handheld. Kinda want to stay away...
Following... short DL here also. 26.5" Sent from my SM-S727VL using Tapatalk
My rigged up arrow runs about 420 grains. With a FOC about 12%. It does seem ti hit harder on all targets. With this FOC I noticed much better...
One would fit on my smoker just about right.
Where I hunt you can't leave tree stands or ground blinds. Some one would steal them.
After having two knee surgeries last year, I am having difficulty climbing trees and treestands. Thinking about getting one of those ghillie...
My arrows are cut about 1/2 inch in front of my rest at full draw. Just be sure that the broadhead clears the sight window.
I welded an allen wrench to a long cold rolled bar. Then welded a "T" onto the other end. Be sure and use some loctite on the insert weight before...
The AAE fastset has held on the same two dozen arrows since this post. So I am going to "stick" with this glue.
It has been real bad around here this year. Numbers are real low (some say 90 percent).
Been using a Bowtech since 2004.
Separate names with a comma.