Does anyone have the pinwheel on target 2 that can run a setup for me? Cant get it to download on my new computer.
Bow: 2016 prime rival 28.25" 65# approx 75% let off Arrow: (might not be on there but the fatboy is very close to this) Easton superdrive 23 375 spine s nock and bushing 125 tips 21 grains added for fletching (aae stealth max) Trying to figure out what best length to cut it at for that spine and tip combo
I do not have that shaft in my database on my OT2. You cannot just substitute the fatboy in its place because the fatboys come in either .340 or .400 spine and the shafts you are asking about is a .375. You would not get an accurate spine match substituting the fatboys in place of your shafts. *EDIT* I was able to select "shaft not in database" and input all of the fields with the correct arrow specs. 27" puts it dead center on spine, assuming all of the fields are correct. Here is a photo, make sure everything looks correct.
Rerun that with 1/4 to 1/2 inch less to put him on the right of the green ( or select the hunting filter)
