Cam timing

2010 mathews z7...new string, new cable and a new cam to have the correct draw length. Ata is 30 inches as it is suppose to be. Noticed the timing for the cam is now off. Never delt with that so im not sure what to do. Heard several things as in twist the string and cable. Back off poundage (which i shouldnt have to due to it was fine til the string cable and cam change). Any and all advice would be great. Thanks..

Sent from my SM-N920P using Bowhunting.com Forums mobile app

 

Seansoutdoors on you tube hope it helps

Sent from my H1611 using Bowhunting.com Forums mobile app

 

dont mess with poundage, jsut your control cable

 

Need to twist or untwist your control cables.. then check again..

 

Got it. Just never had to do that with my old mathews. Thanks!!!

Sent from my SM-N920P using Bowhunting.com Forums mobile app

 

Just curious what was it

 

Had to twist the cable to shorten it. Never came across that issue before til this bow. Then i had to twist the right side yoke only while untwisting the left side to get it paper tuned.

Sent from my SM-N920P using Bowhunting.com Forums mobile app

 

Yep that will do it!! My bow only has control cables, so for paper tuning all I have is the rest for tuning. Unless of course my nock position is bad. Happy you got it dialed in..

 

It was a pain at first til i figured out how to do it then it wasnt so bad. Sucked pressing the bow, twisting the string, un doing the bow and doing it all over. Til it was good to go. Lol

Sent from my SM-N920P using Bowhunting.com Forums mobile app

 

But that's 1/2 the fun of it.. I'm in the middle of testing out different sight combinations right now. So I hear ya, but I'm getting into IBO so pins and sights need to be completely clear.