Results 1 to 10 of 10
  1. #1
    SMbowhunter is offline Junior Member Newb
    Join Date
    Sep 2013
    Location
    Around Greenville SC
    Posts
    8
    Post Thanks / Like

    Trophy ridge revolution arrow rest

    Hey everyone got a question about my new trophy ridge revolution arrow rest first of all works great shooting tighter groups and no problems with clearance at all my problem lies with the the rest not wanting to lock until I reach full draw. I can close it but the slightest bump and it opens and arrow fall out. Has anyone had this happen can it be tightened up or fixed or do I need to contact trophy ridge any help much appreciated

  2. #2
    Revonoc6's Avatar
    Revonoc6 is offline Member Newb
    Join Date
    Apr 2013
    Location
    Merced, CA
    Posts
    32
    Post Thanks / Like
    It isn't supposed to close up till full draw unless you do it manually. But if you do it manually you may wear out the finish on your rest. I used to close mine manually when I first got it and I could manhandle the hell out of my bow and it would stay shut. I would have it looked at, it may be defective. I also have a Trophy Ridge arrow holder on my shelf so that I don't have to close my rest and don't have to worry about the finish on the shelf or the arrow being marred by friction. Those help with silencing your draw also and run about $8 on Amazon. I hope this helps. The revolution is a pretty good rest and once you get it set up to suit you, I'm sure you'll be happy with it.
    PSE Drive 31"/68#
    Apex 4-pin sight
    Trophy Ridge Revolution drop away
    Victory V-Force V6 350
    NAP Thunderhead 100gr

  3. #3
    Revonoc6's Avatar
    Revonoc6 is offline Member Newb
    Join Date
    Apr 2013
    Location
    Merced, CA
    Posts
    32
    Post Thanks / Like
    Trophy Ridge Drop Zone Arrow Rack

    This is what I'm talking about.
    PSE Drive 31"/68#
    Apex 4-pin sight
    Trophy Ridge Revolution drop away
    Victory V-Force V6 350
    NAP Thunderhead 100gr

  4. #4
    SMbowhunter is offline Junior Member Newb
    Join Date
    Sep 2013
    Location
    Around Greenville SC
    Posts
    8
    Post Thanks / Like
    Yep works great love it. I was under the impression that it is a full capture before you draw and you can let you arrow down slowly with out it poping, if I try to let down it pops open and my arrow falls out

  5. #5
    Revonoc6's Avatar
    Revonoc6 is offline Member Newb
    Join Date
    Apr 2013
    Location
    Merced, CA
    Posts
    32
    Post Thanks / Like
    I can let down slowly, actually... not so slowly, and it will stay shut... maybe mine is the defective one. lol
    PSE Drive 31"/68#
    Apex 4-pin sight
    Trophy Ridge Revolution drop away
    Victory V-Force V6 350
    NAP Thunderhead 100gr

  6. #6
    Acts of the wolf is offline Senior Member Weekend Warrior
    Join Date
    Sep 2012
    Location
    East Wakefield New Hampshire
    Posts
    160
    Post Thanks / Like
    ^^^^ same here.
    2012 Diamond Dead Eye
    30" 63#
    Trophy Ridge Revolution
    Apex 4 pin sight
    Octane quiver
    Octane stab
    CX Mayhem Hunters
    100gr NAP Kill zones
    100gr Magnus Bullheads
    Nockturnals

  7. #7
    SMbowhunter is offline Junior Member Newb
    Join Date
    Sep 2013
    Location
    Around Greenville SC
    Posts
    8
    Post Thanks / Like
    No u talked to trophy ridge and it's defective got a new one all ready no problems has any one hooked one up with out putting the timing line in the Bus cable and serving it? I no that ripcord comes with a little football clamp but I can't find one any other ways anyone have suggestions

  8. #8
    SMbowhunter is offline Junior Member Newb
    Join Date
    Sep 2013
    Location
    Around Greenville SC
    Posts
    8
    Post Thanks / Like
    Miss type I ment: No I talked to trophy ridge and it's defective got a new one all ready no problems has any one hooked one up with out putting the timing line in the Bus cable and serving it? I no that ripcord comes with a little football clamp but I can't find one any other ways anyone have suggestions

  9. #9
    Revonoc6's Avatar
    Revonoc6 is offline Member Newb
    Join Date
    Apr 2013
    Location
    Merced, CA
    Posts
    32
    Post Thanks / Like
    Nope, mine is served into the bus cable. My pro shop did it for $5 and it took about 5 min. I would trust serving over a clamp.
    PSE Drive 31"/68#
    Apex 4-pin sight
    Trophy Ridge Revolution drop away
    Victory V-Force V6 350
    NAP Thunderhead 100gr

  10. #10
    T.McCormick is offline Junior Member Newb
    Join Date
    Sep 2013
    Location
    Calabogie, Ontario, Canada
    Posts
    7
    Post Thanks / Like
    It sounds like your rest isnt set just right. If its dropping your arrow before you shot or just when you let it down it might not lock completely. Make sure when your arrow nocked and your rest down that the rest is close to 180 degrees from your arrow. This should give it the room to rotate an lock securely. The rest should not hug or hold the arrow tight untill your at full draw or manually push it against the arrow.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •